How to Prepare for Massage Cupping Session

• Clean cups in light warm, salty water; and dry thoroughly. Always work with clean cups in every massage cupping session.
• Set room temperature to warm.
• Wash & clean your body thoroughly – especially the target areas. Remove any body hair.
• Moisturize after showering, so your skin won’t be dry during the session. Dry skin will lead to potential skin breaking during the cupping session.
• Assemble the massaging cupping suction handgun, to the cups.
• Apply oil or skin cream again onto the target area.
• Begin your massage cupping session.

You will need:

• Massage cupping set
• Oil / skin cream
• Light warm salty water

Warning:
- Use for no more than 15 minutes per target area, 1-2 times daily, 10 days/area (After 10 days, give the area a rest of at least 1-2 days)

How to use: Massager Cupping 6 Set

• Place one of the Rubber Suction Connector (green arrow-looking piece) onto the Suction Hand Gun. Arrowhead facing out.
• Before attaching the Suction Cup, make sure the Yellow Plug in the cup is NOT pushed down. If the Yellow Plug is pushed down, gently pull up the plug to allow air to go through.
• Choose & connect a Suction Cup of your choice into the Rubber Suction Connector.
• Smear an appropriate amount of oil, or skin cream onto target area
• Place the Suction Cup to the desired location on the body
• Pump the Suction Hand Gun handle to withdraw air from the cup.
• Remove Connector & Suction Hand Gun to leave cup attached to skin by vacuum pressure.
• To remove the cup, pull up on the cup’s valve to release the vacuum pressure.

How to use: Massager Cupping 12 Set

• Place one of the Rubber Suction Connector (green arrow-looking piece) onto the Suction Hand Gun. Arrowhead facing out.
• Take the connecting tube and connect it to the gun, through the Rubber Suction Connector.
• Take the second Rubber Suction Connector, and connect it to the other end of the connecting tube. Arrowhead facing outward.
• Before attaching the Suction Cup, make sure the Yellow Plug in the cup is NOT pushed down. If the Yellow Plug is pushed down, gently pull up the plug to allow air to go through.
• Choose & connect a Suction Cup of your choice into the Rubber Suction Connector.
• Smear an appropriate amount of oil, or skin cream onto target area
• Place the Suction Cup to the desired location on the body
• Pump the Suction Hand Gun handle to withdraw air from the cup.
• Remove Connector & Suction Hand Gun to leave cup attached to skin by vacuum pressure.
• To remove the cup, pull up on the cup’s valve to release the vacuum pressure.

* Note:
- Cups may be moved while attached.

- Use cream or oil as a lubricant to allow cupping of larger areas, or to easily adjust the placement of the cup.

- When moving a cup, grip the cup low on the bowl, and use the fingers of the non-pulling hand to gently hold the skin taut behind the cup as it moves.

- During each cupping session, keep the room warm.

- It is normal for darkening to appear on the skin where cups are applied. This will dissipate in a few days.

- Blisters may appear where the cup has been attached. When the blistering is serious, routine sterilization is necessary. Prick the blisters and apply disinfectant.

How to Clean Massage Cupping Set

• Remove all cups from the box.
• Fill a clean bowl with warm water
• Add salt to the warm water, making it lightly salty
• Wash cups & dry thoroughly. Make sure the inside of the cup is completely dry before using.

You will need:

• Massage Cupping Set
• Bowl
• Warm water
• Salt
• Paper towel / clean dry cloth

Note:
make sure the inside of the cup is clean, and the assembly is intact (valve & seal are firmly fastened to cup) before performing cupping procedure.

How to Treat Body After Massage Cupping Session

After a massage cupping session it is common for the cupping areas to turn a different color. That color will subside after a few days, but sometimes people may get blisters after a session. Blisters are serious, and require routine sterilization when necessary. How do you treat them?

You will need:

• Disinfectant solution
• Cotton ball
• Needle
• Aloe

• Sterilize the needle with disinfectant solution.
• Use the needle to prick the blister
• Apply disinfectant to the blister using a cotton ball

Optional:
Apply Aloe when necessary to assist in the healing process.

Note:
- When showering, clean affected areas gently.
- Any broken skin should also be disinfected using a clean cotton ball.
- Drink lots of water & moisturize to keep skin hydrated, and for faster healing.